Inline duct fan Ø 150 mm energy-saving and quiet – CA 150 ES

Warning: this symbol indicates that care must be taken to avoid injury to the user

• Do not use this appliance for functions other than those described in this booklet.
• After removing the appliance from its packaging, ensure that it is complete and undamaged. If in doubt contact a professionally qualified electrician or Vortice. Do not leave packaging within the reach of children or infirm persons.
• Certain fundamental rules must be observed when using any electrical appliance, including:
• never touch electrical appliances with wet or damp hands;
• never touch appliances while barefoot;
• never allow children or infirm persons to operate appliances unattended.
• Store the appliance out of the reach of children and differently able persons after deciding to disconnect it from the power supply and use it no more.
• Do not us the appliance where flammable vapours are present (spirit, insecticides, petrol, etc.).

Caution: this symbol indicates that care must be taken to avoid damaging the appliance

• Do not make modifications of any kind to this appliance.
• Do not expose this appliance to the weather (rain, sun, etc.).
• Do not place objects on top of the appliance.
• Regularly inspect the appliance for visible defects. If the appliance does not function correctly, do not use it and contact Vortice immediately.
• If the appliance does not function correctly or develops a fault, contact Vortice immediately and ensure that only genuine original Vortice spares are used for any repairs.
• Should the appliance be dropped or suffer a heavy blow, have it checked immediately by Vortice.
• The appliance must be installed by a professionally qualified electrician.
• The mains power supply to which the units are connected must comply with current laws.
• The electrical power supply/socket to which the appliance is to be connected must be able to provide the maximum electrical power required by the appliance.
• Use a suitably sized multi-polar switch with minimum contact gaps of 3 mm to install the appliance.
• Switch off the appliance at the installation's main switch: a) if the appliance does not function correctly; b) before cleaning the outside of the appliance, c) if the appliance is not to be used for any length of time.
• Ensure that the room has an adequate source of fresh air to ensure correct appliance operation. In the event that other non-sealed combustion-based appliances (such as water heater or gas stove) are installed in the same room, check that air replacement is sufficient for all appliances to work effectively together.
• The appliance cannot be used to control activation of water heaters, room heaters, etc. and it must not exhaust into the hot air flues.
• Ensure that the appliance discharges into a single duct (dedicated to this product) or directly to the outside.
• The appliance’s inlet and outlet ports must always be connected to a suitable duct.
• The maximum ambient temperature for the proper functioning of the appliance is 50° C.
• The overtemperature and overload protection is assured by the fuse and the control electronics.
• Specifications for the power supply must correspond to the electrical data on data plate A (Fig.1)

Source: manufacturer's operating instructions (Vortice CA ES 0-10V, page 9).