Deutsch
English
Ceiling fan Vortice Nordic TROPICAL 140 EVOLUTION IPX5 WE
The Tropical ceiling fan is an industrial ceiling fan that is ideal for use in agriculture, outdoors, in greenhouses, damp rooms and commercial and industrial areas with increased occurrence of moisture, wetness, dust and dirt. Through special encapsulation of the motor and connections and the anti-corrosive coating of the components, protection class IPX5 is achieved.Advantages of the Nordic TROPICAL IPX5 ceiling fan at KlimaLex
Design
Ceiling fan in an attractive design. Housing made of galvanized sheet steel with double baked enamel finish, aluminum blades, baked enamel in light gray.
Quality
Ball-bearing, lifetime-lubricated and self-cooling motor that is dynamically balanced and equipped with thermal overload protection for quiet running. Not suitable for mounting lights!
Safety
Protection class I, protection type IPX5, max. ambient temperature 45°C, radio-interference suppressed.
Performance
The powerful motor provides good air output and distribution.
Moisture-protected
Designed with rubber seals to protect against dust and moisture
Control
Without built-in pull switch. Wall controllers and control transformers can be used.
ATTENTION:
When controlled with a remote control, no IPX5 splash-water protection is possible!
Easy to install
Simple and quick mounting by means of a robust hook fastening.
Variable
The ceiling rod supplied can be shortened by sawing it off.
Separable by material type
At the end of the life cycle, all parts can be separated by material type.
Technical information at a glance
- Number of blades: 3
- Motor output: 24 - 70 watts
- Voltage: 230 volts ~ 50 Hz
- Including KlimaLex.de service
- Size: Ø 142 cm
- Number of levels: 1
- Speed: max. 231 rpm
- Protection type IPX5 protected against water jets, insensitive to dirt, dust and water
- Forward/reverse operation
- Color: light gray paint
Wall transformers and controllers, remote controls, control relays, suspension systems for suspended ceilings, SLOW MOTION longer ceiling rods available as accessories.
Safety instructions
Warning: this symbol indicates that care must be taken to avoid injury to the user
- Do not use this product for functions other than those described in the instruction booklet.
- After having removed the product from its packing, ensure that it is complete and undamaged: if in doubt contact Vortice Service Centre.
- Do not leave packaging within the reach of children or differently able persons.
- Certain fundamental rules must be observed when using any electrical appliance:
- Never touch appliances with wet or damp hands
- Never touch appliances while barefoot
- If using this appliance where there are children, supervision by an adult is necessary; this appliance must not be used, without assistance, by children or persons whose physical, sensory or mental capacities prevent them from applying the necessary safety precautions.
- Do not use the appliance where flammable vapours are present (spirit, insecticides, petrol, etc.).
- To conform with applicable standards, the bottom edges of the fan blades must be at a height of at least 2.3 metres or more from the floor (fig.1) in residential premises.
- To conform with applicable standards, the bottom edges of the fan blades must be at a height of at least 2.7 metres or more from the floor (fig.2) in non-residential premises.
- Unauthorised changes to the factory set fitting shall invalidate the guarantee and entitle the manufacturer to disclaim any whatsoever liability.
Caution: this symbol indicates that care must be taken to avoid damaging the appliance
- Do not make modifications of any kind to this appliance.
- The appliance must be installed by a professionally qualified person.
- Regularly inspect the appliance for visible defects. If any faults are found, do not operate the appliance but contact Vortice Service Centre.
- The electrical mains to which the unit is connected must conform to current standard.
- The appliance must be properly connected to an electrical system in compliance with the applicable regulations and equipped with an efficient earthing system. If in doubt, have a qualified electrician perform a thorough check.
- The electrical power source to which the product is to be connected must be able to provide the maximum amount of electrical power required by the product.If it cannot do this, contact an electrician for appropriate remedial action.
- Use a multi-polar switch with minimum contact gaps of 3 mm when installing the appliance.
- Should the appliance be dropped or suffer a heavy blow, have it checked immediately by Vortice.
- If the appliance does not function correctly or develops a fault, turn it off and contact Vortice immediately. Ensure that only genuine original Vortice spares are used for any repairs.
- Do not leave the appliance on unnecessarily: when the appliance is not in use, turn the switch to off.
- Use the unit at an ambient temperature not above 40°C (104°F).
- Place the unit at a suitable distance from walls,objects, etc.
- Specifications for the power supply must correspond to the electrical data on data plate A (fig.3).
Cleaning Before cleaning the unit or carrying out maintenance operations turn the main switch off and remove the plug from the power supply.
Source: manufacturer's operating instructions (Vortice Nordik Tropical IPX5 70).
- Voltage
- 230 V
- Product type
- ceiling fan
- Control
- optional
- Casing
- lightgrey
- Power
- 70 watts
- Manufacturer
- vortice
- Style
- simple
- Blade decor
- lightgrey
- Blade material
- metal
- No. of blades
- 3
- Lighting
- optional
- Diameter in cm
- 142
- Commercial use
- yes
- Outdoor use
- yes
- Sloped ceilings
- suited
- Ceiling distance
- 495 mm - 305 mm
- Forward-/Reverse mode
- reverse direction possible
- 0-10 V interface
- no
- IP protection class
- IPX5
- Shipping Weight
- 7.5 kg